Home
Midnite Solar
Midnite Installation Supplies
Midnite Installation Supplies
-
Midnite Solar, MN3024DIY, is a 3000W, 24VDC Inverter-Charger that Includes a Built-In MPPT Charge Controller
The MN3024DIY is a 3,000W, 24VDC inverter-charger that includes a built-in MPPT charge controller. Offering a simple, all-in-one installation and...
Model: MN3024DIY
Manufacturer: Midnite Solar -
Midnite Solar, MN5048DIY, Hybrid Inverter / Charger
The MN5048DIY is a 5,000W, 48VDC inverter-charger with built-in MPPT charge controller. Offering a simple, all-in-one installation and flexible...
Model: MN5048DIY
Manufacturer: Midnite Solar -
Midnite Solar, MNBABYBOX, Baby Box Enclosure
General use powder coated aluminum enclosure for retrofits, small inverter disconnect, PV disconnect, AC or DC distribution. Used all around the...
Model: MNBABYBOX
Manufacturer: Midnite Solar -
Midnite Solar, MNBACKPLATE, for One Or Two E-Panels, Grey Steel
16 gauge gray steel accepts one or two EPanels, (wide or narrow). Wires route behind the 2" thick plate for a clean installation. Rear cover plates...
Model: MNBACKPLATE
Manufacturer: Midnite Solar -
Midnite Solar, MNBCB 1000/100, Battery Combiner
MidNite 1000amp battery combiner box Includes a 1000amp Positive and Negative bus bar with 3/8 inch studs. Cables can be doule lugged and the copper...
Model: MNBCB 1000/100
Manufacturer: Midnite Solar -
Midnite Solar, MNBCB 1000/50, Battery Combiner
MidNite 1000amp battery combiner box Includes a 1000amp Positive and Negative bus bar with 3/8 inch studs. Cables can be double lugged and the copper...
Model: MNBCB 1000/50
Manufacturer: Midnite Solar -
Midnite Solar, MNBDM, Breaker Disconnect Module, Use With Birdhouse, 24 Vdc or 48 Vdc Input
The Battery Disconnect module is designed to interface with our Birdhouse and turn off any of our shunt trip battery breakers when the Birdhouse is...
Model: MNBDM
Manufacturer: Midnite Solar -
Midnite Solar, MNBE-A, Battery Enclosure w/ Locking Door
ETL listed for the US and Canada for indoor use only. Battery Enclosure with locking door and one shelf. Holds three group 31 or 27 sealed batteries...
Model: MNBE-A
Manufacturer: Midnite Solar -
Midnite Solar, MNBE-D, Battery Enclosure w/ Locking Door
Our Best Value! Battery Enclosure with locking door and two shelves. MNBE-D holds 8 GVX3050T or 8 golf cart or 8 group 31 batteries. With the...
Model: MNBE-D
Manufacturer: Midnite Solar -
Midnite Solar, MNBIGBABY, Load Center, Big Baby Box Enclosure
General use powder coated aluminum enclosure - holds up to 4 13mm wide din rail breakers from 1-63 amps. The original Baby box has been a huge...
Model: MNBIGBABY
Manufacturer: Midnite Solar -
Midnite Solar, MNBIRDHOUSE1-GRAY, Emergency Disconnect Switch
Birdhouse-Gray - Emergency Disconnect Switch has the same capabilities as the Birdhouse-Red. NOTE: IF USING THE BIRDHOUSE FOR JUST SHUTTING DOWN A...
Model: MNBIRDHOUSE1-GRAY
Manufacturer: Midnite Solar -
Midnite Solar, MNBIRDHOUSE1-RED, Emergency Disconnect Switch
Birdhouse - Emergency Disconnect Switch. NOTE: IF USING THE BIRDHOUSE FOR JUST SHUTTING DOWN A BATTERY BASED SYSTEM BREAKER WITHOUT A COMBINER YOU...
Model: MNBirdhouse1-Red
Manufacturer: Midnite Solar -
Midnite Solar, MNCAT5-600-FULLROLL, Cat 5 Cable Roll 1600 Feet
Cat 5 cable sold in complete rolls of 1600 feet. MNCAT5-600 USE-2 600 volt rated cable Shielded Double insulated UV resistant Direct burial...
Model: MNCAT5-600-FULLROLL
Manufacturer: Midnite Solar -
Midnite Solar, MNCLIP1.5KAC0.8, 1, 500 watt AC Clipper for wind or Hydro designed to work with the Midnite Classic.
1,500 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper comes in different resistance values per phase to...
Model: MNCLIP1.5KAC0.8
Manufacturer: Midnite Solar -
Midnite Solar, MNCLIP1.5KAC2.0, 1, 500 watt AC Clipper for wind or Hydro designed to work with the Midnite Classic.
1,500 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper comes in different resistance values per phase to...
Model: MNCLIP1.5KAC2.0
Manufacturer: Midnite Solar -
Midnite Solar, MNCLIP1.5KDC2.4, 1, 500 watt AC Clipper for wind or Hydro designed to work with the Midnite Classic.
1,500 watt DC Clipper for Wind or Hydro designed to work with the MidNite Classic. The Clipper comes in different resistance values per phase to...
Model: MNCLIP1.5KDC2.4
Manufacturer: Midnite Solar -
Midnite Solar, MNCLIP4KAC0.4, 4, 000 watt AC Clipper for wind or Hydro designed to work with the Midnite Classic.
4,000 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper comes in different resistance values per phase to...
Model: MNCLIP4KAC0.4
Manufacturer: Midnite Solar -
Midnite Solar, MNCLIP4KAC1.0, 4, 000 watt AC Clipper for wind or Hydro designed to work with the Midnite Classic.
4,000 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper comes in different resistance values per phase to...
Model: MNCLIP4KAC1.0
Manufacturer: Midnite Solar -
Midnite Solar, MNCLIP4KAC1.6, 4, 000 watt AC Clipper for wind or Hydro designed to work with the Midnite Classic.
4,000 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper comes in different resistance values per phase to...
Model: MNCLIP4KAC1.6
Manufacturer: Midnite Solar -
Midnite Solar, MNCLIP4KAC4.0, 4, 000 watt AC Clipper for wind or Hydro designed to work with the Midnite Classic.
4,000 watt AC Clipper for wind or Hydro designed to work with the MidNite Classic. The Clipper comes in different resistance values per phase to...
Model: MNCLIP4KAC4.0
Manufacturer: Midnite Solar